Rice mills also need maintenance on a daily basis.

Release time:

2022-05-24

The principle of the rice mill is the rotation of the rice grains. The rotation is the rotation of the short axis of the rice grain, and the rotation is the rotation of the short axis of the rice grain. In the whole process of rice milling by the rice milling machine, there are three key points to prevent insufficient or partial over-milling of rice, that is, the rice grains must be turned over so that every position of the rice grains can have an equal opportunity to receive the effect of rice milling, so that the rice milling is symmetrical.

rice millThe principle is that the rice grains rotate and flip. The rotation is the rotation of the short axis of the rice grain, and the rotation is the rotation of the short axis of the rice grain. Inrice millIn the whole process of rice milling, there are three key points to prevent insufficient or partial over-milling of rice, that is, the rice grains must be turned over so that every position of the rice grains can have an equal opportunity to receive the effect of rice milling and make the rice milling symmetrical.

1.rice millRolling caused by white roller ribs

When the rice grain leaves the tendon, the speed direction and the fold line form a viewing angle, so that the rice grain hits and rolls more frequently within a diameter.

Two isrice millThe rice knife and round hole sieve caused the car to roll over.

Moving at the speed of a grain of rice. To the rice knife, jump home at the forefront of the rice knife and so on. Different "angles" cause rice grains to roll and build. When there are more rice knives and round hole screens in the white room, the rolling frequency is more, and vice versa. However, it cannot be increased indefinitely, which is limited by the structure of the whitening room and factors endangering the actual effect of the processing technology.

Third,rice millThe wind caused the roll

Wind-sprayed rice milling has gradually been widely used. Under a certain working pressure, the wind blows from the inside of the whitening roller to the holes or grooves on the surface, and the blowing wind generally exceeds the floating rate of the rice grains. When the gas entersrice millWhen the rice milling chamber, the volume expands, the working pressure decreases, and a mixed airflow is generated. The rice grains roll in the vortex to maintain fitness.

rice millIt is the machinery and equipment for people to process grain and oil. We must maintain it frequently during the entire use process to increase its service life. So...rice millWhat is the usual maintenance?

1.rice millProduction and processing of rice should maintain a certain degree of dry humidity, water content is generally not more than 14%-15%. When the water content of the rice is too high, the rice grains will be greatly crushed, thereby endangering the quality of the rice, and the driving force will be consumed and expanded.

2. Pay attention to check whether there are steel nails, stones and other dirt in the meter to prevent it from blocking or damaging the rice sieve when it enters the whitening chamber.

3. When starting, run to all normal speed ratios without load, then pour the rice into the hopper, and pay attention anytime and anywhererice millingThe operating state of the machine.

4. Check the rice sieve, rice knife, barrel core and other components before starting up to see if the anchor bolts and nuts are tightened.

5. Rotate the drum before starting and check for blockage.

6, after the end of the daily work, rightrice millAnd service facilities to conduct an inspection, found that the problem is properly handled to ensure thatrice millAlways in good condition.