Adjustment of iron roller rice mill manufacturer's machine

Release time:

2022-11-22

Adjustment of iron roller rice mill manufacturer's machine Adjustment of sand. Remove the machine speed cover, loosen the spindle bearing nut, then turn the sand roller to adjust it to be non-skewed, and then tighten the nut to fix the sand roller.

Adjustment of sand. Remove the machine speed cover, loosen the spindle bearing nut, then turn the sand roller to adjust it to be non-skewed, and then tighten the nut to fix the sand roller.

Adjustment of grain inlet gate. Loosening the tightening nut of the inlet ram will open the inlet ram. The size of the opening of the gate depends on the research needs of the driving force of the iron roller rice mill. If the rotation speed of the iron roller rice mill suddenly decreases, the opening of the imported gate will become larger. According to the analysis of the main driving force, the process gate can be adjusted to the appropriate use position, then the nut can be tightened and a fixed gate can be fixed.

Adjustment of inlet and outlet rams. Loosen the tightening screw and mention the inlet and outlet gate. The opening level of the gate is layered by grain and discharged from the rice mouth. The grain is suitable and not crushed. Adjust the torsion screw to secure the brake plate. In the work of rice mill manufacturers, we should also shave bran moderately to prevent the quality of rice.

Air volume adjustment. There are often air volume adjustment plates on both sides of the bran remover. When rice is found around the bran remover, loosen the clamping screw to lift the plate, reduce the air volume at the interface of the bran remover, and it is not easy to suck the rice away. If necessary, lift the inspection cap on the motor shaft to further reduce air flow. Conversely, when it is found that rice contains chaff for a long time, you should learn to put down the inspection cap and air volume adjustment plate, and then fix the adjustment plate at the necessary opening.

Iron roller rice mill manufacturers

Iron roller rice mill operation steps

The iron roller rice mill will stabilize on the workbench and insert the power cord plug.

Remove the whitening time and skip the timer to execute the knob.

Take out the test hopper, take 17-20g of black rice (water content should not exceed 15%) into the feed hopper, let its development into the grinding white room. Press the switch to control the power button to start, and then learn to put down the pressure.

When needed, the iron roller rice mill is fully automatic rotation stop, first take out the hopper to remove the debris. Insert and connect the hopper again, then take it out, turn the front rotating rocker to the left to make the polished rice in the whitening room fall into the hopper, turn the knob to the 0 position regularly, and press the switch power button to make the grinding wheel rotate at high speed for a few seconds. In the whitening room, drop all the small rice grains, then pull them out of the rice receiving barrel, and get the measured polished rice through sieving

Rice mill manufacturers

The key components of the iron roller rice mill are composed of feeding device, white powder chamber, feeding device, gear transmission, blowing system software, etc. The gap between the rice knife and the rice barrel should be appropriate, and the diameter of the gap should not be less than the rice, otherwise the rice grains are fragile; the gap should not exceed the vertical diameter of the rice grains, otherwise the rice grains will not be smooth. Therefore, the gap between the rice knives should be selected in the middle of the horizontal diameter and the vertical diameter of the rice grains. Practice shows that the gap between the rice knives should be slightly rhombic, that is, slightly larger near the end of the knife, so that the grind The rice grains will be more detailed. Import and export guillotine should cooperate well. When the inlet knife is completed, the outlet knife is closed for hours, the white indoor particles increased and the working pressure increased. The milled white is white, but more rice is broken. On the contrary, if the inlet guillotine is reduced and the outlet guillotine is expanded, less rice is stored in the rice milling room, the working pressure is reduced, and the polished rice is less smooth.