Adjustment of the iron roller rice mill manufacturer's machine

Adjustment of the sand. Remove the machine speed cover, loosen the nut of the main shaft bearing, then rotate the sand roller to adjust it to not be skewed, and then tighten the nut to fix the sand roller.

Adjustment of the grain import gate plate. Loosening the tightening nut of the inlet gate plate can open it. The amount of grain entering the machine is determined by the opening level of the gate plate. The size of the gate plate opening depends on the driving force of the iron roller rice mill. If the speed ratio of the iron roller rice mill suddenly decreases, the data shows that the opening of the inlet gate plate will become larger. According to the main driving force analysis situation, the process gate plate can be adjusted to the appropriate usage position and then the nut can be tightened. Fix a stationary gate plate.

Adjustment of the inlet and outlet gate plates. Loosen the tightening screws and lift the inlet and outlet gates. The opening of the door is horizontally layered with grains, which are discharged from the rice opening. The grains are appropriate and not crushed. Adjust the torque screw to fix the brake plate. When the rice mill manufacturer is in operation, we should also moderately remove the bran to prevent the quality of the rice from deteriorating.

Air volume regulation. There are often air volume adjustment plates on both sides of the chaff remover. When it is found that there is rice around the chaff removal area, loosen the clamping screws to lift the plates, reducing the air volume at the interface of the chaff remover and making it difficult to suck away the rice. If necessary, the inspection cap on the motor shaft can be lifted to further reduce the airflow. Conversely, when it is found that the rice has been containing chaff for a long time, one should learn to lower the inspection cap and the air volume adjustment plate, and then fix the adjustment plate at the necessary opening.

Iron roller rice mill manufacturer

Operating steps of the iron roller rice mill

The iron roller rice mill will be stabilized on the workbench and the power cord plug will be inserted.

Remove the whitening time and jump the timing execution knob.

Take out 17-20g of black rice from the detection hopper (the moisture content should not exceed 15%) and put it into the feeding hopper. Let it develop and then pour it into the whitening room. First, press the power button to start the switch, and then learn to release the pressure.

When necessary, the iron roller rice mill is fully automatic and stops rotating. First, take out the hopper to remove the debris. Insert and connect the hopper again, then take it out. Turn the front rotating rocker to the left to make the polishing rice in the whitening chamber fall into the hopper. Regularly turn the knob to the 0 position and press the power switch button to make the grinding wheel rotate at high speed for a few seconds. In the whitening chamber, all the millet grains are dropped and then pulled out from the rice receiving bucket. Through sieving, the measured polished rice is obtained

Rice milling machine manufacturer

The key components of the iron roller rice mill consist of the feeding device, white powder chamber, gear transmission, and blower system software, etc. The gap between the rice knife and the rice cylinder should be appropriate. The diameter of the gap must not be smaller than the rice grains; otherwise, the rice grains are prone to breakage. The gap must not exceed the vertical diameter of the rice grain; otherwise, the rice grain will not be smooth. Therefore, the gap between the rice knives should be selected in the middle of the horizontal and vertical diameters of the rice grains. Practice shows that the gap between the rice knives should be slightly rhombic, that is, slightly larger near the end of the knife. In this way, the rice grains milled will be more delicate. The inlet and outlet knife switches should be well coordinated. When the water inlet gate knife is completed and the water outlet gate knife is closed for a few hours, the number of particles in the ground white chamber increases, and the working pressure rises. The ground white is white, but more of the rice is broken. On the contrary, if the inlet gate knife is reduced and the outlet gate knife is expanded, less rice will be stored in the rice milling chamber, the working pressure will decrease, and the polished rice will be less smooth.