Let me tell you about the service life of a household rice mill

The entire assembly process and common problems of household rice milling machine parts

A household rice mill is composed of many parts. Assembling these components into a device with specific performance parameters is a complex and meticulous task. The quality of assembly will immediately affect the rationality, reliability and service life of the sand roller household rice mill. Here, the assembly of typical parts with symbolic significance and wide application is introduced in detail.

Before assembly, each assembly part should be carefully cleaned. Throughout the assembly process, cleanliness must be strictly maintained. All stains on the assembly surface and non-assembly surface will cause substantial damage to the parts, making the household rice mill unable to operate normally. Parts that have been punched, reamed or drilled should be cleaned through air compression.

2. When assembling, apply grease to the friction surfaces of the parts to ensure that the household rice mill is fully lubricated when it starts to operate. The felt oil retaining ring needs to be cleaned neatly and then soaked in car oil so that the oil can seep in.

3. When disassembling and replacing during maintenance, it is essential to strictly pay attention to the thickness of the gasket, as the thickness of the gasket usually determines the assembly gap between components, thereby endangering the technical characteristics of the household rice mill. During installation, a layer of grease should be applied to both sides of the gasket (outside the diesel engine cylinder), and the gasket should not have defects such as wrinkles, cracks, uneven thickness, overlapping or cylinder opening.

4. When installing parts that require precise positioning, it is essential to check each other's positions and orientation marks, and adjust the clearances to ensure the normal operation of all parts. For instance, when assembling the piston rod and crankshaft, pay attention to the orientation. The timing transmission gears must ensure that the fuel supply is interrupted, as this may lead to accidents. Correct ignition and valve timing.

By doing so, the household rice mill will have a longer lifespan

The principle of a household rice mill is to turn the rice grains over. It is the rotational movement of the rice grains in the short axis direction. The rotation is the movement of the grains in the short axis direction. During the entire process of milling rice into rice, it needs to go through the pressing movement to ensure that all positions of the rice grains can equally receive the function of the household rice mill, making the milling uniform and preventing insufficient milling or partial overmilling.

After milling rice, it is necessary to maintain a certain level of dryness and humidity. Generally, the moisture content should not exceed 14%. When the moisture content of rice is too high, it will be crushed into rice, endangering the quality of rice. The driving force for consumption is also related to the expansion of rice.

2. Pay attention to checking whether there are any steel nails, stones or other contaminants in the rice to prevent them from entering the rice milling room and causing blockage or damage to the rice sieve.

3. When starting up, run the machine without load to all normal speed ratios, then pour the straw into the hopper and keep an eye on the operation of the rice at all times.

4. Before starting, inspect the rice cutter, core cylinder and other components, and check whether the anchor bolts and nuts have torque.

5. Before starting, rotate the drum and ask if there is any blockage.

6. After work every day, check the household rice mill and service facilities once. Deal with any problems in time to ensure that the household rice mill is always in good condition.

That's all for today's introduction from the editor. Thank you all for watching. See you next time.