A rice thresher is a machine that naturally produces rice when grains are put in. In rural areas, many families make rice by threshing machines. While the rice thresher is threshing rice, chaff also comes out on the other side. Chaff is the crushed chaff. Chaff can be used to feed chickens and domestic pigs.

Principle of rice milling machine

The structure of the grinding type sand roller rice mill consists of a frame and a suction mechanism. The rice milling chamber is fixed on the frame, the feeding device is installed at the upper part of the rice milling chamber, and the chaff collection hopper is installed at the lower part of the rice milling chamber.

2. The main shaft in the rice milling chamber is a hollow shaft. The air inlets are located at both ends of the hollow shaft. The rice outlet is equipped with a device for cleaning and cooling the rice. The inclined guide plate is installed inside the rice outlet, and the lower part of the guide plate is equipped with a device for cleaning and cooling the rice. The features of the grinding type sand roller rice mill are that the pressure in the rice milling chamber is relatively low and the linear speed of the rice milling roller is relatively high.

3. As grinding only occurs between the rice milling roller and the brown rice, as well as between the brown rice and the bran discharge cylinder, and with the negative pressure bidirectional multi-channel air intake, the rate of broken rice during the rice milling process is low. During the working process, brown rice enters the end of the rice milling chamber from the feeding hopper through the flow regulation mechanism and is pushed into the interior of the rice milling chamber by the rotating screw propeller. When the brown rice fills the rice milling chamber, the pushing screw continues to push the brown rice in.

4. The pressure in the rice milling chamber keeps increasing. When the pressure of the brown rice group is large enough to overcome the resistance of the pressure door at the discharge port, the discharge port opens, and the rice grain group is discharged from the rice milling chamber. The brown rice is constantly subjected to grinding from the inlet to the outlet of the rice mill, and the bran layer is gradually peeled off to become rice bran, which is discharged through the holes of the bran discharge cylinder, and then the rice milling is completed. A device for cleaning and cooling the rice is installed at the discharge port to further cool the rice grains.

Precautions for rice milling machine

Before the brown rice enters the hopper, it is necessary to check for any metal objects or stones to avoid damaging the grinding wheel.

After the whitening process is completed, the front rotating block should be pulled out to clean up any remaining rice sugar in the whitening chamber to avoid affecting the accuracy of the sample.

3. The milling accuracy should be determined by the variety of brown rice, including the number of samples and the milling time. For low-precision samples, a quantity of 17-18g is appropriate, and the milling time should be slightly shorter. The quantity of high-precision samples is preferably 20g, and the whitening time should be slightly longer.

4. When the rice mill has been in use for a long time and has milled brown rice with excessive moisture, causing the rice bran to stick to the grinding wheel and affect the whiteness, you can remove the grinding wheel with a wrench, brush off the bran powder with a wire brush, and reinstall it in its original position for continued use.

The operating procedures of the rice thresher are as follows:

Before starting work, check whether all parts of the rice mill are firm and whether the pressure rollers are normal.

2. Check if the counter is in good condition and adjust the distance between the aisles according to the specifications of the rubber hoses.

Before threshing the rice, set the counter to zero first.

When feeding the rubber hose into the pressure roller, keep your hand 20 cm away from the pressure roller to avoid hand injury from being squeezed.

V. During the rice milling process, if any problem occurs, the machine should be stopped immediately for resolution. It is strictly prohibited to handle it while the machine is running.

Six. When handling rubber hoses, cooperate well with each other to prevent damage from being hit or squeezed.

7. Shutdown: After work is completed, turn off the power and clean up thoroughly.

Viii. Others: When using a toothless saw, follow the technical operation procedures for toothless saws.