The preparatory work before starting up the complete set of rice milling equipment manufacturer: Check whether all parts of the equipment are normal and whether the connections are loose. Check whether the pulleys of each machine operate smoothly and if there is any friction, and whether the round hole screens of the equipment are clogged. Check whether each water inlet and the inlet pipe are blocked, and whether the water gate is closed. Check the lubrication of each rotating part. After everything is normal, it can be started. Pay attention to the first short-term idle run. When the equipment operates stably and everything is normal, production and processing can begin. The operation process of using a complete set of rice milling equipment manufacturer is as follows
1. Processing flow: Precisely weighed raw grains are added to the silo. Start first, then open the water-saving port of the feeding port to operate quickly and practically, so that the precision of the finished product exceeds the specified limit. The actual operation time does not exceed 5 minutes. The finished products with lower precision at the beginning will be returned to the machine after the third sampling and all coarse grains will be cleaned.
2. Current, working voltage and speed ratio. Immediately after the test begins, measure the current and working voltage every five minutes. After the test is normal, measure the speed ratio twice for each test and record it.
3. The use of time and electromagnetic energy. The entrance gate opens and the countdown begins. When all the coarse grains are based on the water-saving port of the feed inlet, the countdown is completed. In addition, the initial and final readings of single-phase instruments record relative times.
4. Rice temperature. Within 50 minutes after the test starts, use some thermometers to measure the temperature of the coarse grains and the temperature of the finished products in the finished product basket.
5. Rolling bearing temperature. At the beginning and end of the test, please use some thermometers to measure the surface temperature of the rolling bearing housing.
6. Dust concentration standards. The measurement was carried out in the room. Ten minutes after the experiment began, a dust sampler was used to select two measurement points within the activity range of the operators at the feeding station and the rice husk collection station for sampling, and the dust concentration standard was measured.
During the noise measurement process, the height of the microphone of the noise meter is 1 meter away from the surface of the equipment, and the height-to-width ratio of the road surface is 1.5 meters. Measure the four points on the front, back, left and right sides.
Changzhou Wujin Shuanghu Grain and Oil Machinery Co., Ltd. is a manufacturer of rice milling machines and rice milling equipment, as well as a complete set of rice milling equipment. If you need to consult which complete set of rice milling equipment is good? Welcome to consult.