Rice milling equipment manufacturer: operation essentials of rice milling machine-which is the best complete set of rice milling equipment

Release time:

2020-08-12

Rice milling equipment manufacturer: operation essentials of rice beater-which is the best complete set of rice milling equipment? 1. Before the brown rice enters the lower hopper, please check whether there are metal objects and stones to avoid damage to the grinding wheel. 2. After the whitening is completed, pull out the front rotating block to clean the remaining rice sugar in the whitening room, so as not to affect the accuracy of the sample. 3. The rice milling accuracy of the white mill needs to determine the number of samples and the whitening time according to the type of brown rice. The number of low-precision samples was 17-18g and the whitening time was slightly shorter; the number of high-precision samples was 20g. Whitening time is slightly longer. 4. After the machine is used for a long time,

Rice Milling Equipment Manufacturer: Operation essentials of Rice Beater-complete sets of rice milling equipment which is good?

1.Before the brown rice enters the lower hopper, please check whether there are metal objects and stones to avoid damage to the grinding wheel.

2.After the whitening is completed, pull out the front rotating block to clean the remaining rice sugar in the whitening room, so as not to affect the accuracy of the sample.

3.The rice milling accuracy of the white mill needs to determine the number of samples and the whitening time according to the type of brown rice. The number of low precision samples is17-18g, The whitening time is slightly shorter; the number of high-precision samples is20g. The whitening time is slightly longer.

4.After the machine is used for a long time, the high-moisture brown rice is crushed, and the rice bran is tied with the grinding wheel to affect the whiteness. The grinding wheel can be removed with a wrench, and then the rice bran can be wiped off with a wire brush to directly use it.

Proper use of householdRice BeaterThe steps:

INSTALLATION CHECK

（1）.The rice mill shall be installed on a cement foundation prepared in advance. The bottom surface of the rice mill shall be in good contact with the foundation. There should be no clearance before tightening the anchor bolts to ensure the spindle after tightening the anchor bolts. Concentric with the screen frame. If the foundation is uneven, causing the spindle to be eccentric, phenomena such as rice grains in rice grains, rice chipping, and eccentric wear of the sieve will occur.

（2）.After hanging the V-belt connected to the electric motor (or diesel engine), remove the discharge port, drum nut, drum, sieve rod and propeller, and measure whether the main shaft is in the center. If the spindle is found to be eccentric, the following adjustments shall be made:

A, left and right eccentric. Loosen the four connecting bolts between the blower housing and the rice mill base, but do not remove them. Add an adjusting shim at the connection position, add a shim on the right, add a shim on the left, and then Add an adjusting shim on the left until the adjustment is not off-center.

B, upward bias. Loosen the four connecting bolts between the blower housing and the rice mill base, but do not remove them, and add adjusting shims on both sides until the top and bottom are not eccentric.

C, tilt down. Loosen the four connecting bolts between the suction housing and the base of the rice mill, but do not remove them, and add adjusting shims on both sides until the top and bottom are not eccentric.

（3）.Since the bolts of the rice mill joint may be loosened during transportation, the following parts of the newly purchased rice mill should be checked:

A, Check whether the two nuts that fix the large pulley on the shaft are tightened.

B, Remove the bearing caps at both ends of the large pulley, remove the locking plate, and check whether the nut locks the fastening bushing.

C, Check whether the flat head bolts that fix the small pulley of the suction fan and the small pulley of the blower on the shaft are fastened.