Complete sets of rice milling equipment which is good? First to understand the work flow of complete sets of rice milling equipment

Release time:

2020-09-21

With the continuous development of agricultural economy, the use of complete sets of rice milling machine, complete sets of rice milling equipment is more and more widely. Which is the best complete set of rice milling equipment? The following equipment operation process is very important to production, let's take a look.

Preparation before start-up of complete rice milling equipment in 1.
1. Before starting the whole machine, please install the machine smoothly, check whether the parts are normal, whether the parts and their connections are loose, whether the transmission belt is tight enough, and it must be flexible when pulling. Each gearbox component can be lubricated only after the above-mentioned parts have been inspected.
2. Remove the debris in the rice to be milled to avoid accidents. Check whether the dryness and wetness of the rice meet the requirements, then insert the rice barrel into the board tightly, and put the rice into the rice barrel to beat.

Technical Requirements for 2. Rice Milling Equipment after Startup
1. Turn on the power and let the rice mill idle for 1 to 3 minutes until the operation is stable, then slowly pull out the feeding blade for cutting, and then put it into use.
2. Check the quality of milled rice at any time. If the quality does not meet the requirements, you can adjust the discharge blade or adjust the gap between the rice knife and the grinding core. The method is: if there is too much grain, first adjust the discharge plate to properly reduce the outlet of the rice, if the rice outlet is adjusted to be smaller but still contains more grain, the gap between the rice knife and the grinding core must be adjusted smaller; if there is a lot of broken rice, the gap between the rice outlet or the rice cutter and the heart grinder should be increased.
3. After the rice milling knife has been used for a period of time, if it is not sharp due to wear and tear, the rice milling knife can be turned around for use. If any rice leaks from the sieve, it should be replaced with a new one. If the peeling rate of the rice husk peeling machine decreases, the interval between the two rubber bars should be adjusted. If the adjustment is invalid, the rubber rod should be replaced.
4. At the end of rice milling, please tighten the paddle board first to crush all the rice in the milling room, and then cut off the power after the machine is discharged.

Maintenance of 3. complete set of rice milling equipment after shutdown
1. If the temperature of the bearing box is found to be too high, lubricating oil (such as butter) should be added.
2. A complete and detailed inspection of the subject.
3. It is strictly prohibited for people who are not familiar with the use and maintenance of rice mills to operate, so as not to cause unnecessary losses.
complete sets of rice milling equipment which is good? changzhou wujin shuanghu grain and oil machinery co., ltd. is a complete set of rice milling machine, complete sets of rice milling equipment professional manufacturer, if there is a demand welcome to consult.