Principle, Precautions and Usage Specification of Rice Beating Machine

Rice BeaterIt's a machine that puts the grain in and makes the rice naturally. There are many families in the countryside who beat rice through a rice machine.Rice BeaterAt the same time as the rice is beaten out, there is chaff coming out on the other side. The chaff is the broken chaff. Bran can be used to feed chickens and domestic pigs.

Rice BeaterPrinciple:

1. Grinding sand roller rice machine structure, which is composed of a frame and an exhaust fan. The rice milling chamber is fixed on the frame, the feeding device is installed on the upper part of the rice milling chamber, and the chaff collection hopper is installed on the lower part of the rice milling chamber.

2. The main shaft in the rice milling chamber is a hollow shaft. The air inlet is located at both ends of the hollow shaft. The rice outlet is equipped with a rice cooling machine device. The inclined guide plate is installed in the rice outlet. The lower part of the guide plate is equipped with a rice cooling device. The grinding sand roller rice machine is characterized by lower pressure in the rice milling chamber and higher linear speed of the rice milling roller.

3. Since grinding only exists between the rice milling roller and brown rice, brown rice and the chaff row cylinder, plus negative pressure two-way multi-channel air inlet, the rice crushing rate in the rice milling process is low. During the working process, the brown rice enters the end of the rice milling chamber through the flow regulating mechanism from the feeding hopper, and is pushed into the inside of the rice milling chamber by the rotating screw propeller. When the brown rice fills the rice milling chamber, the screw propeller still pushes the brown rice in continuously.

4. The pressure in the rice milling chamber continues to increase. When the pressure of the brown rice group is large enough to overcome the resistance of the pressure door of the discharge port, the discharge port is opened, the rice grains are discharged from the rice milling chamber, and the brown rice is discharged fromRice BeaterFrom the inlet to the outlet, it is always subjected to grinding, and the skin layer is gradually stripped to become rice bran, which is discharged through the holes of the bran cylinder, and then rice milling is completed. The outlet is equipped with a device for cleaning and cooling rice to further cool the rice grains.

Rice BeaterNote:

1. Before brown rice enters the hopper, check whether there are metal objects and stones to avoid damage to the grinding wheel.

2. Pull out the front rotating block after grinding white, and clean up the rice sugar in the residual grinding white room, so as not to affect the accuracy of the sample.

3. The white grinding precision shall be determined by the variety of brown rice to determine the number of samples and the white grinding time. The number of low-precision samples is 17-18g, and the white grinding time is slightly shorter. The number of high-precision samples is 20g, and the white grinding time is slightly longer.

4, whenRice BeaterAfter long use time and high moisture content brown rice, when the rice bran bonding grinding wheel affects the whiteness, the grinding wheel can be removed by a spreader, the bran powder can be removed by a steel wire brush, and the bran powder can be removed by loading it back according to the original sample.

Rice BeaterThe operating procedures are as follows:

1. inspection before commencementRice BeaterWhether all parts are firm and whether the pressure roller is normal.

2. check whether the counter is in good condition and adjust the clamping distance according to the specifications of the hose.

Set the counter to the zero position before the 3. hits the meter.

When the 4. hose is fed into the pressure roller, the distance between the hand and the pressure roller shall be kept at a distance of 20 ㎝ to avoid the hand being squeezed.

In the process of 5. rice beating, if there is any problem, it should be stopped immediately to solve it, and it is strictly prohibited to deal with it during operation.

6. and handling hoses shall be well coordinated with each other to prevent smashing or squeezing injuries.

Seven shutdown: the end of the work, turn off the power supply, clean up the health.

Eight other: the use of toothless saw when the implementation of toothless saw technical procedures.