Maintenance of New Combined Rice Milling Machine

Release time:

2023-01-11

The new combination rice mill is one of the grain equipment that farmers need very much. The role of the new combination rice mill is believed to be known to many people. The use has brought a lot of convenience to our life and made our eating easier. Delicious and time-saving in daily life, especially some rice processing plants, are used every day, then, let's take a look at the maintenance of the new combination rice mill.

1. new combination of rice milling machine maintenance:

1. Clean appearance: If there is dust on the appearance of the rice mill, it can only be wiped with a dry cloth, especially the screen part. If there are mosquitoes on the glass surface of the touch screen, please clean it to avoid affecting the touch effect.

2. Internal cleaning: It is recommended to clean the inside of the rice mill with a vacuum cleaner once a month. If there is too much bran dust, it will cause the rice mill motor to malfunction.

3. When the rice mill is stopped, a little lubricating oil is often added to the bearing bush to make it run faster.

4. Leakage protection switch: perform leakage protection operation once a month, press the leakage protection button, the main switch will automatically reset, indicating that the protection state is normal.

5. When operating the rice mill, do not let children play nearby to avoid injury.

6. After the rice milling knife is used for a certain period of time, if it is not sharp due to wear, the rice milling knife can be turned over for use. If the rice sieve leaks, it should be replaced with a new one.

7. Check the quality of rice milling at any time. If the quality does not meet the requirements, you can adjust the oil drain plug or adjust the gap between the rice mill and the rice mill. The method is: if there are more rice grains, adjust the drain pad first and reduce the amount of rice produced accordingly (if the amount of rice produced is less, the amount of rice grains is still more, and the gap between the rice knife and the grinding should be reduced to the center); If there are more, the output of rice (or the gap between the rice knife and the grinding center) needs to be increased.

8. If the temperature of the bearing bush is found to be high, lubricating oil (such as butter) should be added. large rice milling machine

Key maintenance parts of 2. new combination rice milling machine:

1. Lubrication: For bearings with fixed-point lubrication parts, the lubricating oil or grease should be sufficient and clean, and the quality and grade of the lubricating grease should meet the requirements; according to the specified time (generally about 3 months of operation), clean the bearing and change the oil; high temperature Check the bearing temperature. Explain why.

2. Inspection:

(1) The assembly parts of the rice milling room shall be kept flat and smooth, and the sieve bars and rice knives shall be kept flat.

(2) When a large amount of bran appears in the rice, it should be stopped for inspection. Pull out the shaft of the rice mill to check whether the grinding wheel is offset from the main shaft of the rice mill, that is, whether the air blowing hole of the grinding wheel is aligned with the main shaft;

(3) After the sand roller is worn, the gap between the screen and the sand roller becomes larger, and the rice knife needs to be adjusted to supplement; when the radius of the grinding wheel is worn to 5-10mm, the grinding wheel should be replaced.

The above introduction is the maintenance of the new combination of rice milling machine. If you need to know more, you can contact us at any time! Our company has many years of experience and looks forward to your joining at any time.